Replacing a Failed or Misted Rooflight

Can a leaking rooflight or skylight be resealed?

Sometimes, and more often than not it is the wrong answer. In a properly built installation sealant is a secondary line, and the water is being kept out by the geometry of the detail rather than by adhesive. Where sealant is doing the primary job it will fail again, so a reseal buys a season or two rather than fixing anything.

What actually keeps water out

Height, laps and drainage.

A kerb tall enough, a covering dressed up it and terminated under the frame, and channels that release anything that gets past, are what make a rooflight dry.

None of those is a sealant.

What sealant is for

Closing a small gap, in support of the detail.

Used properly it fills a joint that the geometry has already made watertight, and it is the belt rather than the braces.

Why it fails

Movement, and ultraviolet. A building moves, aluminium expands and contracts daily, and a bead that started continuous develops a hairline path that water finds.

Why a roof is hard on it

Sun and standing water together. Sealant on a roof takes far more ultraviolet than a wall joint and often sits under standing water, and both shorten it considerably.

Where a reseal genuinely works

A sound detail with a tired bead.

Where the kerb is right, the covering is dressed correctly and only a secondary joint has perished, replacing that bead is a legitimate repair.

How it is done properly

Cut out, clean back, prime, reapply. The old sealant is removed completely, the surfaces are cleaned to sound material, the right sealant for those surfaces is used, and it is tooled rather than smeared.

Why the old bead has to come out

Because new sealant does not bond to old.

Running a fresh bead over a perished one bonds to something that is already failing, which is why that repair lasts a winter.

A misted sealed unit seen from below inside a room, the haze and mineral staining between the panes clearly visible against a bright sky
Choosing the right sealant

Choosing the right sealant

It matters more than people think. Different materials suit different substrates and different movement, and a general purpose tube from a shed is rarely the right specification for a roof joint.

What a bead round the outside does

Makes things worse, usually. Sealing the perimeter of a drained system traps the water it is designed to release, so the frame holds water instead of shedding it.

Why that is such a common mistake

Because it appears to work.

The leak stops for a season while water accumulates where it cannot get out, and when it reappears it is worse and much harder to understand.

Blocked weeps mistaken for a leak

The fault a reseal makes permanent.

Drainage holes silted up will back a system up over the frame, and sealing round the outside at that point closes the last route out.

Clearing them is on do electric rooflights need servicing.

Where the kerb is too low

No amount of sealant helps.

An upstand built short lets driving rain reach the frame line, and sealing that joint is asking adhesive to do a job that height was supposed to do.

The requirement is on how high should a rooflight kerb be.

Where the covering lap is wrong

The other unsealable fault.

Where a covering is dressed the wrong way relative to the frame, water is being directed inward, and sealant is holding back a flow rather than closing a gap.

Where the gasket is the problem

On an opening unit, and it is not a sealant question.

A dirty or set gasket, or an actuator not pulling the sash home, leaves the seal uncompressed, and cleaning or adjusting is the repair.

That is on do opening rooflights leak more than fixed ones.

Where the fault is above the rooflight

Frequently, and it is the wrong thing being sealed.

A slipped tile or a covering fault higher up the roof sends water down to the rooflight, which is where it shows rather than where it entered.

A replacement rooflight sitting on a new kerb on a flat roof, the line of the old weathered kerb still visible in the membrane around it
Diagnosing before deciding

Diagnosing before deciding

The step that saves the money.

A hose test from the bottom upward finds the entry point, and only then is it possible to say whether a bead is the right repair.

The method is on why is water coming in around my rooflight.

What a reseal buys you

Time, honestly stated.

Where a proper repair is planned for later, a competent reseal can be a sensible holding measure through a winter, provided everybody knows that is what it is.

Liquid applied repairs

A genuine option, and a different thing.

A liquid membrane detail dressed over an upstand is a repair to the covering rather than a bead of sealant, and it can be a proper fix where the geometry is sound.

What we would do instead

Correct the detail.

Raise a low kerb, redress a covering, renew a flashing, clear the drainage. Every one of those is a permanent answer where sealant is a delay.

Tape and patch products

Useful for an emergency, not for a repair.

Self adhesive flashing tapes will hold water back for a season and they are made to be a temporary measure, which is a reasonable thing to use while a proper repair is arranged.

Left as the answer, they lift at the edges and trap water underneath.

Paint on waterproofers

The same caution, applied more widely. Brushed coatings over a whole detail hide the geometry underneath, so the next person cannot see what is happening and the fault becomes harder to diagnose.

What to do while you wait

Clear rather than seal. Clearing debris off the roof, unblocking the outlets and clearing the weep holes are all free, reversible, and occasionally they turn out to have been the whole problem.

What we find

We find where the water is entering before we decide anything, and we say when a reseal would only be buying a winter, because a sealed perimeter on a drained system is worse than the leak it hid.

The whole picture is on the replacing a failed or misted rooflight page.

Thinking about this job? We survey across Worthing, West Sussex and the South Downs and give you a fixed price before any work starts, with a 10-year workmanship guarantee.

Get a fixed quote

Get a fixed quote

Tell us about the roof. We will tell you the price.

A survey costs you nothing and there is no obligation attached to it. We look at the roof build-up, the exposure and the opening, and give you one fixed figure, not an estimate that moves once work starts.

If your rooflight is leaking now, say so and we will prioritise the survey.

  • Fixed price, confirmed in writing
  • 10-year workmanship guarantee
  • Installed to current Building Regulations
  • Your roof is never left open overnight
Call Get a fixed quote