How much does it cost to replace a rooflight?
Less than fitting a new one, because the opening, the trimming and usually the kerb are already there. What a replacement costs turns on how much of the existing construction survives, how the old unit was fixed, and what is found once the covering comes back. The timber underneath is the item that can change the figure on the day.
What a rooflight or skylight quotation is made of
The general anatomy is on how much does a flat roof rooflight cost.
What follows is what changes when there is already a rooflight in the roof.
What carries over
Most of the construction.
The structural opening, the trimming around it, generally the kerb, and often much of the internal reveal are all in place, and those are the expensive parts of a new installation.
What does not
The weathering and the making good. The covering has to be lifted and reinstated, the flashing or the kerb detail renewed, and the plaster line around the opening will be disturbed.
Like for like
The cheapest version of the job. Same size, same product family, into the same opening, is a lift, a swap and a reinstatement, and on a straightforward roof it is a day.
What that involves is on can a rooflight be replaced in the same opening.
A different size
Where it stops being a swap. Any change in size means new trimming, more covering work and a new reveal, and a change in width can mean structural work.
That is on do I have to replace like for like.
A different product
Sometimes free and sometimes not.
Swapping a dome for a flat glass unit on the same kerb can be straightforward. Swapping a pitched window for a different manufacturer means a new flashing kit.
The pane only route
The cheapest option of all, where it applies.
Where only the sealed unit has failed and the glass is beaded rather than bonded, replacing the pane leaves everything else alone.
That is on can just the glass be replaced.

The timber underneath
The variable that cannot be priced from the ground.
If a long standing leak has been getting into a kerb or a trimmer, that timber is cut out and replaced before anything new goes in.
What it involves is on what happens if the timber underneath has rotted.
How that is handled in a quotation
Honestly, as a stated possibility. A quotation that says what happens if rot is found is more useful than one that pretends it will not be, and it avoids a difficult conversation on the day.
The kerb
Sometimes reused and sometimes rebuilt.
A sound, square, properly insulated upstand is reused. One that is too low, poorly insulated or out of square is rebuilt, and that is a real item.
The requirements are on how high should a rooflight kerb be.
The covering
Where the roof type shows. Dressing a new detail into felt, single ply or a liquid system are three different jobs, and an old brittle covering is more work than a recent one.
On a pitched roof
The flashing kit and the courses. A new kit for the covering is a modest item, and setting the tiles or slates back so the courses run true is where the time goes on an old roof.
Getting to the roof in How much does it cost to replace a rooflight?
The same variable as any roof job.
A tower, a scaffold or a lift each suit different heights and ground conditions, and where a scaffold cannot be stood the method changes.
Whether it can be avoided is on can you replace a rooflight without scaffolding.
Making good inside
Budgeted rather than hoped for. Even a perfect swap disturbs the plaster line, so a replacement is a roofing job followed by a small plastering and decorating one.

Doing several at once
Where the saving is largest. Access, protection and setting out happen once, so three tired rooflights replaced in a single visit cost considerably less than three separate jobs.
Doing it with a roof recovering
The cheapest moment of all. Where a flat roof is due to be recovered, replacing the rooflight at the same time shares the access, the covering work and the kerb detail entirely.
Upgrading while you are there
Worth considering rather than defaulting. Better glass, solar control, or an opening version cost little more than a like for like unit at the point of ordering and cannot be added later.
Where a whole new unit beats a repair
An old unit in a cold room.
Repairing a very old rooflight leaves you with old performance, and where the room is cold the money often does more as a replacement.
The comparison is on will a new rooflight be warmer.
Why we do not publish figures
Because what is under the covering decides it.
Two identical looking rooflights, one on sound timber and one on rotten, are different jobs, and a single figure would be wrong for one of them.
What a survey establishes
Four things, and each of them moves the figure.
The product and how the glass is held, the state of the kerb or the flashing, the condition of the covering around it, and whether the access needs a tower or a scaffold.
None of those can be judged from a photograph of the ceiling.
Where the room decides the cost
The finishing rather than the roofing. A rooflight in a garage is a roof job. The same rooflight in a decorated kitchen carries protection, clearing, plastering and decorating behind it.
How we quote it on a replacement
We quote the swap and state separately what happens if the timber is wet, so a homeowner knows the range before we start rather than hearing about it from a roof.
The whole picture is on the replacing a failed or misted rooflight page.
Thinking about this job? We survey across Worthing, West Sussex and the South Downs and give you a fixed price before any work starts, with a 10-year workmanship guarantee.