Roof Lantern Installation

Do roof lanterns leak?

A well made lantern on a well built kerb does not leak. Almost every failure we are called to is at the junction between the two, or at a kerb that was built badly in the first place. The lantern is a drained system designed to shed water it takes in, and it works reliably when the perimeter beneath it does its part.

Why a flat roof rooflight leaks

The general mechanism, and the kerb reasoning, is on do flat roof rooflights leak.

This page covers what is specific to a structure with glazing bars and a ridge.

How a lantern actually drains

Not by being sealed.

Water passing the outer gasket runs into channels formed in the glazing bars, down to the eaves beam, and out over the kerb through weep holes at the perimeter.

It is designed to take water in and get rid of it.

Why that matters

Because it changes what a failure looks like.

A drained system that is working correctly will have water inside its bars, and the presence of water there is not itself a fault.

A fault is water arriving in the room.

Blocked weeps

The commonest actual fault on an installed lantern.

The holes at the eaves that let the channels discharge silt up with dust, moss and leaf debris, and once they are closed the channels fill and back up over the frame.

Clearing them is a few minutes with a soft brush.

Where the eaves beam meets the kerb

The junction everything depends on.

The covering has to come up the kerb and terminate under the frame, so any water reaching the top of the upstand is already outside the building.

Where that lap is the wrong way round, the water goes in.

A kerb that is too low

The failure that shows up in a storm rather than in rain.

An upstand built shorter than it should be lets driving rain and standing water reach the frame line, and the lantern is then relying on sealant rather than on height.

The heights are on how high should a rooflight kerb be.

A roof lantern over a dining table in a rear extension seen from the far corner of the room, flat daylight falling down the walls, plain furnishings, no people
A kerb that is out of square

A kerb that is out of square

Where the packing and sealant start.

A rigid frame on an unsquare perimeter leaves a gap at one corner that gets filled rather than closed, and that is the corner that leaks in five years.

Relying on sealant anywhere

The sign of an installation to worry about.

Sealant is a secondary line in a properly built detail. Where it is doing the primary work, it will fail, because it moves and the building moves at different rates.

Ponding on the roof

A cause rather than a symptom.

Water standing against a kerb because the flat roof has insufficient fall will find any weakness given long enough, and that is a roof problem rather than a lantern one.

The falls are on what is the minimum fall for a flat roof with a rooflight.

Where the ridge caps meet

A workmanship point on assembly.

Ridge and hip cappings have to be bedded and fixed as the manufacturer specifies, and a cap left short or a gasket left proud is an entry point at the highest part of the structure.

Movement in the glazing bars

Where a lantern that was fine starts to weep.

Bars spanning further than they should deflect under snow and wind, and that movement works the gaskets until they stop sealing at the same point every time.

The spans are on how big can a roof lantern be.

Thermal movement

Real, and designed for on a good system.

An aluminium frame in full sun expands measurably, and systems allow for that at the joints. Ones that do not, or ones assembled tight, work themselves loose.

Condensation mistaken for a leak

Very common on a lantern.

Water running down the inside of the glass in a kitchen in January is almost always condensation, and it appears in the same place as a leak would.

How to tell is on is it condensation or a leak.

The eaves beam of a roof lantern where it sits down on its kerb, seen close from inside, the thermal break and the glazing gasket running along the frame
Why a kitchen lantern condenses

Why a kitchen lantern condenses

Because of what happens beneath it.

Cooking, kettles and a dishwasher put a great deal of moisture into a room, and the coldest surface in it is the glass overhead.

Extract and warmth do more about it than anything on the lantern does.

A cold kerb

The other thing mistaken for a leak.

An uninsulated or partly insulated upstand runs wet in winter and drips at the reveal, which looks exactly like water coming in around the frame.

It is insulation rather than sealant that fixes it.

Diagnosing an existing lantern

In order, and it usually resolves quickly.

Check the weeps, look at where the water appears and when, establish whether it happens in rain or in cold, and look at the kerb before touching the lantern.

What we would not do

Run a bead of sealant round the outside.

Sealing the perimeter of a drained system traps the water it is designed to release, and the leak gets worse in a way that takes a while to understand.

Where a leak shows up in the room

Rarely directly beneath where it got in.

Water entering at the head of a kerb runs along the top of a ceiling or down a joist before it drops, so a wet patch at one corner of a reveal can be a fault a metre away.

Which is why the roof is looked at rather than the ceiling.

Testing it

With a hose, methodically, from the bottom up.

Water is run at the lowest part of the detail first and worked upward with time between each stage, because wetting everything at once tells you nothing about where it entered.

It is slow and it is the only reliable method.

Where we start on a lantern

We look at the kerb first on every leak we attend, because in almost every case the lantern is doing what it was made to do and the upstand is not.

The whole picture is on the roof lantern installation page.

Thinking about this job? We survey across Worthing, West Sussex and the South Downs and give you a fixed price before any work starts, with a 10-year workmanship guarantee.

Get a fixed quote

Get a fixed quote

Tell us about the roof. We will tell you the price.

A survey costs you nothing and there is no obligation attached to it. We look at the roof build-up, the exposure and the opening, and give you one fixed figure, not an estimate that moves once work starts.

If your rooflight is leaking now, say so and we will prioritise the survey.

  • Fixed price, confirmed in writing
  • 10-year workmanship guarantee
  • Installed to current Building Regulations
  • Your roof is never left open overnight
Call Get a fixed quote