Areas We Cover

Rooflight and Skylight Installation in Pulborough

  • Fixed quote before we start
  • Roof never left open overnight
  • 10-year workmanship guarantee
Skylight installation on a home in Rooflight and Skylight Installation in Pulborough, flat overcast daylight
  • Fixed quote before we start
  • 10 years workmanship guarantee
  • 25 years fitting rooflights
  • Skylights only, not a general roofer

Pulborough sits on a sandstone ridge with the Arun brooks spread out below it, and that position produces a condition we see here more than anywhere else inland: roof spaces that run damper than they should. It is not a rooflight problem and it becomes one, because a cold surface in a humid loft collects water and the rooflight gets the blame.

What we install in Pulborough

Replacements and flat roof rooflights, on a mixture of village stock and later housing along the ridge.

The replacements are units at the end of their lives in the older and inter-war housing. The flat roof work is over rear extensions, as it is everywhere.

What is different is what we check before fitting either, and it is the roof space rather than the roof.

The brooks, and the air over them

The local condition, and it is worth setting out because it is not obvious.

The Arun floodplain below the village is wet ground for much of the year, and the air over it holds moisture accordingly. On still cold mornings that air pools in the low ground and drifts up against the ridge.

Properties on the lower slopes, and anything with an aspect over the brooks, sit in noticeably more humid air than a comparable house a few miles inland. Over years that shows up inside roof spaces rather than outside.

A damp roof space, and what it does
Symptom What it means What fixes it
Water on the underside of the felt Humid, poorly ventilated roof Ventilation at the eaves
Damp insulation at the eaves Path blocked, air not moving Clear the path, add trays
Staining on rafter tops Long standing condensation Ventilation, then time
Water round a new rooflight Usually the roof, not the unit Diagnose before replacing
Mould on stored items Humidity, not a leak Ventilation and vapour control
Only after cold nights Condensation Not a flashing question

Why it gets blamed on the rooflight

The sequence is predictable and it is worth explaining to a household before it happens.

A roof space has been quietly humid for years and nobody notices, because there is nothing cold enough in it to condense on. Then a rooflight goes in, and its frame is the coldest surface in the loft.

Water forms on it, runs, and appears at the ceiling. The unit is a week old, so the unit is the suspect. It is not the unit; it is the roof space, and the unit merely revealed it.

What we check before fitting

On any property on the lower slopes here, this happens before an order goes anywhere.

Whether the eaves ventilation path is open or packed solid with insulation. Whether there is felt, and whether it is a breathable membrane or a bitumen felt that is not. Whether there is any staining on the rafters already.

Where the roof space is already marginal, it is put right first. Adding a cold surface to a humid unventilated loft and calling it finished is not something we will do.

Eaves ventilation, and clearing it

The commonest single remedy, and it is inexpensive at the right moment.

Insulation added in layers over decades is generally packed hard into the eaves, closing the path that lets air move through the roof. Clearing it, and fitting trays to hold the path open, restores the ventilation the roof was designed to have.

It is a morning’s work when somebody is already in the loft forming an opening, and a separate visit afterwards.

A small inland Sussex market town of brick and tile buildings on a gentle slope, the Downs a low pale line on the southern horizon
The vapour control layer at the frame

The vapour control layer at the frame

The other half, and it is done at installation or not at all.

Where a rooflight passes through a ceiling, warm humid room air will find any gap around the frame and go up into the roof space. Sealing the vapour control layer to the frame stops that at the source.

In a bathroom or a kitchen it matters more, and on a property beside the brooks it matters more again, because the roof space it would be feeding is already close to its limit.

The street up the ridge

The shape of the old village, and it affects access rather than specification.

The historic street climbs from the bridge up onto the ridge, with buildings tight to it and a designation over the older part. It is steep, narrow in places, and carries traffic.

A scaffold occupies the street rather than standing beside it, and a scaffold on a slope needs more base work than one on the flat. Both are settled at survey and priced as their own line.

Buildings above and below the street

A specific consequence of building on a slope.

Properties on the downhill side sit below the road, so their roofs are seen from above by anybody on the pavement. Properties on the uphill side are the reverse.

Which means the assumption that a rear slope is private does not survive contact with the topography here, and visibility is checked on foot from the street rather than assumed from a plan.

What the Pulborough stock asks for

The older village buildings carry conditions set out in full elsewhere.

Timber frames on the oldest stock are on the Steyning page. Hand made clay tile is on Sussex clay peg tile. Horsham stone, where it appears, is on Horsham stone slab roofs. Lath and plaster is on West Tarring.

Each is established at survey. None is peculiar to this village.

The later housing along the ridge

Twentieth century development above and behind the old street, and it is where most of the work is.

A mixture of cut and trussed roofs depending on the decade, clay and concrete coverings, and rear extensions with flat decks. Ordinary work, and the roof space check still applies on anything with an aspect over the brooks.

Where the roof is trussed, the widths available are on trussed rafters and the widths that fit between them.

Flood zone, and what it does not affect

Worth clearing up, because the brooks make people ask.

Parts of the low ground here sit in a flood zone, which is a planning consideration for new building and for changes of use. It is not a consideration for a rooflight, which alters nothing about how a ground floor performs in a flood.

Where a property is being altered more broadly it can matter. On a rooflight alone it does not arise.

A Wealden village street of timber framed and tile hung houses with heavy Horsham stone slab roofs, damp grey daylight
Damp in the building, as distinct from the roof

Damp in the building, as distinct from the roof

A distinction worth drawing on properties near the water.

Rising and penetrating damp in walls, and humidity in a roof space, are different problems with different causes and different remedies. A rooflight touches neither.

Where we see signs of the first we will mention them and we will not offer to diagnose them, because that is somebody else’s expertise. What we will do is make sure the roof work does not make the second worse.

Wealden shelter and valley air

The environmental position, which is comfortable in one respect and not in another.

Well inland, so the salt question does not arise and standard architectural coatings hold up. Wind loading is ordinary in the valley.

What the position does give is fog and prolonged damp, which slows drying and shortens the working day in winter more than an equivalent inland village would.

Extract fans that vent into the loft

A recurring find here and it is the single largest contributor to a humid roof space.

A bathroom or kitchen extract ducted into the roof void rather than out through the roof or the wall puts a great deal of warm wet air directly into the space, every day, for as long as it has been there.

It is common, it is easy to miss, and it is cheap to correct while somebody is already up there. Where we find one on a Pulborough job we will say so, because fitting a rooflight above it without mentioning it would guarantee a callback.

The bridge, and what comes over it

A practical access note for the lower part of the village.

Traffic through Pulborough funnels over the river crossing, and at busy times a delivery or a scaffold lorry trying to stop on the approach is not a realistic proposition.

Deliveries are arranged for a window early in the day and the unit goes straight in rather than standing on the verge. It is a small piece of planning that saves an awkward hour.

Sandstone, and what a scaffold stands on

A ground condition specific to the ridge.

The village sits on sandstone, which drains well and is stable, and the slopes below it are a different matter after prolonged rain. A scaffold base on the lower ground needs proper sole boards and spreading.

On the ridge itself the ground is as good as anywhere we work, which is a small compensation for the gradient.

Rooms in the roof with a view

A local reason people want windows placed a particular way.

From the upper slopes the outlook south and west over the brooks is long and open, and a window positioned for that sits lower on the slope than one placed for daylight so somebody seated can see out.

That pushes it toward the eaves, where the rafter depth and the wall plate become the constraint, and on a property where the eaves ventilation also has to be preserved the two requirements have to be reconciled rather than traded.

A tile hung Sussex farmhouse with a steep clay peg tile roof, mature oaks around it, low cloud over the Weald
Working days in a wet season

Working days in a wet season

A practical consequence rather than a technical one.

A roof that stays wet until late morning is a roof nobody should be walking on, and in the valley in winter that is many mornings. Jobs here occasionally start later in the day than they would elsewhere.

It is built into the date rather than the invoice, and an opening is never left unweathered overnight.

What the survey establishes

  • Whether the eaves ventilation path is open or blocked.
  • Whether there is felt, and what kind.
  • Whether the rafters show existing condensation staining.
  • The property’s aspect and height relative to the brooks.
  • Whether the roof is cut or trussed.
  • Whether the slope is overlooked from the street above or below.

Building Control

A replacement into an existing opening is not normally notifiable, though the unit still has to meet the limiting thermal standard. A new opening is, and goes to Horsham District Council or an approved inspector.

The thresholds are on do flat rooflights need Building Control.

Permitted development

Outside the designation most work here falls within permitted development, subject to the projection limit above the plane of the roof and nothing forward of the principal elevation.

In the old street those rights are narrowed and the topography makes visibility harder to judge than usual, so it is worth establishing rather than assuming. Which applies to a specific address is settled before a unit is specified.

How we quote

A free indicative range by email from photographs, then a survey, then a fixed itemised written price that does not move afterwards. Anything we misjudge at survey is ours to absorb.

What is measured at each step is on the how we price and quote page.

Guarantee

Ten years on our workmanship, on every job, limits written down. The manufacturer stands behind the unit; we stand behind the kerb, the flashing and the making good.

The terms, and the accreditations we do not claim, are on the our guarantee page.

Skylight services in this area

Thinking about this job? We survey across Worthing, West Sussex and the South Downs and give you a fixed price before any work starts, with a 10-year workmanship guarantee.

Get a fixed quote

Questions we get asked here

Do I need planning permission for a rooflight in Pulborough?

Horsham District Council is the planning authority for Pulborough, and it is the one to ask rather than the district you might assume. Conservation area over the old street and around the church. Permitted development here is narrowed in the designated area, standard on the estates. We check the designation and the elevation before anything is specified, because on a designated slope the product follows the planning position rather than the other way round.

What will you find on a Pulborough roof?

Clay plain tile and Horsham stone. Cut roofs, timber frames on the older stock. Dressed soakers; made-up lead on stone. That is what a survey confirms on your roof rather than assumes from the street.

Does being in Pulborough change what you would specify?

Arun valley, sheltered; standard coatings. It is a specification decision taken at order rather than something that can be improved afterwards, which is why we raise it before a unit is chosen.

How would you get to the roof in Pulborough?

Old street constrained, estates easy. Access is the largest single variable between two otherwise identical jobs, so it is settled at survey by standing in the garden rather than judged from a photograph.

Get a fixed quote

Tell us about the roof. We will tell you the price.

A survey costs you nothing and there is no obligation attached to it. We look at the roof build-up, the exposure and the opening, and give you one fixed figure, not an estimate that moves once work starts.

If your rooflight is leaking now, say so and we will prioritise the survey.

  • Fixed price, confirmed in writing
  • 10-year workmanship guarantee
  • Installed to current Building Regulations
  • Your roof is never left open overnight
Call Get a fixed quote