Start from the floor area of the room, then check it against the length of the run. A small diameter suits a cloakroom or a small landing. A larger one suits a bathroom, a hallway or a bigger landing. And where the run is long, the next size up is worth having, because a wider tube loses proportionally less light on the way down.
Start with the floor area
The simplest guide, and it works.
Manufacturers publish a suggested floor area for each diameter, and those figures are a reasonable starting point for an ordinary run.
The small diameters
A cloakroom, an ensuite, a small landing.
A modest tube lights a small enclosed space properly, and in a room of a few square metres it does everything you would want.
The middle diameters
The commonest choice. A bathroom, a hallway or a landing of ordinary size is served well by a mid range tube, and that is what goes into most houses.
The large diameters
A big hallway, a stairwell, a kitchen corner.
The largest tubes deliver a great deal of light and need a correspondingly larger hole in both the roof and the ceiling.
Why the run changes the answer
Because length costs light. A tube that suits a room over a two metre run may be inadequate over five, so the diameter is checked against the distance rather than the area alone.
The mechanism is on how much light does a sun tunnel give.
Why a wider tube goes further
Fewer reflections for the same distance. Light travelling down a wider tube strikes the walls less often, so it arrives with more of itself intact, which is why diameter helps on a long run.
Bends and the size decision
Each one argues for a bigger tube.
A route with an elbow in it loses a meaningful proportion, and going up a size is the straightforward way to compensate.
That is on can a sun tunnel go round a corner.

Rigid or flexible changes it too
More than the diameter does. A rigid tube at a given size delivers considerably more than a flexible one, so tube type is decided before diameter rather than after.
The comparison is on what is the difference between rigid and flexible sun tunnels.
What the roof allows
A constraint on the largest sizes. The roof unit fits between rafters or trusses, so the clear space between members can rule out the biggest diameter on a particular roof.
The spacing question is on can a sun tunnel go through a loft.
What the ceiling allows
Rarely a limit, and worth checking.
A diffuser opening may cross a ceiling joist, which is trimmed as ordinary carpentry, and a larger diameter makes that more likely.
Two small ones or one large
Two, in a room of any length.
Two tunnels spread across a hallway light it evenly, where one large one in the middle produces a bright centre and dark ends.
Where one is clearly right
A small square room. A cloakroom, a small bathroom or a compact landing is lit properly by a single well positioned tunnel, and a second adds nothing.
Where the diffuser should go
Central, unless something says otherwise. The middle of the ceiling gives the most even spread, and moving it toward the darkest part of a room is a reasonable adjustment.
Positioning against the run
The compromise worth making. Shifting a diffuser slightly to line up with a straight route is almost always a better result than a perfectly centred diffuser on a bent one.
Going one size up
Cheap insurance. The step in cost between diameters is modest against the job, and a tunnel that disappoints on a grey day cannot be enlarged afterwards.
Where the money goes is on how much does a sun tunnel cost.

Whether it can be too big
Practically, no. Excess daylight in a hallway is not a problem people report, and the limits are the roof structure and the cost rather than the room.
Solar gain from a large one
Negligible. The area is small and the diffuser scatters what comes down, so a sun tunnel does not overheat a room the way a rooflight can.
The rooflight case is on will a rooflight make my room too hot.
What a north slope changes
Very little at the same size. Diffuse skylight is what most of the output is, so orientation is a smaller factor than length or tube type.
That is on do sun tunnels work on a north facing roof.
Matching an existing tunnel
Worth doing where two are in one space.
Two diffusers of different diameters in one hallway ceiling read as an accident, so a second tunnel added later is generally matched to the first.
The diffuser appearance
Part of the size decision in the room.
A larger diameter means a larger circle in the ceiling, and in a small room that is a visual element as well as a light source.
What the manufacturer figures assume
A stated run and a rigid tube.
Published floor area guidance is given for a particular configuration, so the same diameter over a longer or a flexible run is serving a smaller room than the table suggests.
A stairwell rather than a room
Sized for the landing rather than the whole void.
A tunnel over a stairwell lights the top of it well and the bottom much less, so it is sized for the level the diffuser is in rather than for the total floor area.
How we size it on a sun tunnel
We size from the area and then check it against the measured run, and where the two disagree we go up a size, because it is the cheapest decision in the job.
The whole picture is on the sun tunnel installation page.
Thinking about this job? We survey across Worthing, West Sussex and the South Downs and give you a fixed price before any work starts, with a 10-year workmanship guarantee.