Self cleaning glass is one of the few rooflight options that is genuinely useful and routinely oversold. It works, it works by a mechanism with clear conditions attached, and on this coast one of those conditions is only partly met.
Two mechanisms, not one
A self cleaning coating is a very thin transparent layer on the outer surface of the outer pane, and it does two separate things.
It breaks down organic dirt
The coating is photocatalytic. Under ultraviolet in daylight it drives a reaction that gradually decomposes organic material sitting on the glass: leaf residue, bird droppings, general grime, the biological film that grows on any outdoor surface.
It makes water sheet rather than bead
The coating is hydrophilic, which is the opposite of a water repellent treatment. Water spreads into a continuous film rather than forming droplets, and that film runs down the glass carrying the loosened dirt with it.
Both halves are needed. The first loosens, the second removes.
Why sheeting matters more than beading
It is counterintuitive, because water repellent treatments on car windscreens work the other way.
Beads of water run down a pane in tracks, leaving the glass between them untouched, and each bead dries where it stops and leaves its dissolved solids behind as a spot. A continuous film wets the whole surface, carries dirt with it, and dries evenly without spotting.
Which is why self cleaning glass produces a noticeably more even, less streaky surface after rain than ordinary glass does.
The conditions it needs
| Condition | Why | On a rooflight here |
|---|---|---|
| Daylight, including ultraviolet | Drives the photocatalytic reaction | Always available, even overcast |
| Rain reaching the glass | The film has to form | Yes, it is overhead |
| Enough pitch to run off | The film has to move | The variable, see below |
| Dirt that is organic | Only organic material decomposes | Partly. Salt and sand are not |
| Time | The reaction is gradual | Weeks rather than hours |
Pitch is the deciding factor
The coating loosens dirt and gravity removes it. Where water sits rather than running, the mechanism stalls at the halfway point.
On a lantern, which is pitched by definition, run off is good and self cleaning works well. On a pitched roof window it works well. On a flat roof rooflight set at the minimum fall it works considerably less well, because the water spreads into a film and then largely stays there and dries in place.
Manufacturers state a minimum pitch, and it is worth taking seriously rather than treating as a formality. Below it the coating still decomposes organic dirt and nothing carries it away.

Where it earns its place
- A lantern. Good pitch, large area, and completely inaccessible for cleaning. The best case there is.
- A pitched roof window on a north facing slope. Stays damp, grows more algae than other orientations, and the coating is working against exactly that.
- Any unit that is genuinely hard to reach. High on a slope, over a stairwell, on a terrace with no access.
- Under trees. Where organic debris is the dominant soiling, which is what the coating is best at.
Where it does less
A flat rooflight at minimum fall. A unit that is easy to reach and gets cleaned anyway. And, importantly on this coast, anywhere salt is the dominant deposit.
Salt, and the honest limitation
This is the point that matters most here and it is rarely stated in the marketing.
Sea salt is not organic. The photocatalytic half of the coating does nothing to it, because there is nothing to decompose. The hydrophilic half helps, in that rain sheeting across the glass will dissolve and carry some of it away, and it helps less than it does with organic soiling.
So within a mile or two of the Channel, a self cleaning coating reduces the frequency of cleaning rather than removing the need for it. It is still worth having. It is not a substitute for an occasional rinse on a coastal roof.
Sand and grit
The same argument, for the other coastal deposit.
Fine sand blowing off the beach is mineral, so it does not decompose. It does wash off reasonably well with a good sheeting film on a pitched unit, and it accumulates in any recess or at the head of a unit where the film slows down.
Which means a recessed installation, which is frequently the right choice for appearance, slightly reduces what a self cleaning coating achieves. It is a small effect and it is worth knowing the two decisions interact.
It is not a coating that wears out
A common concern, and a reasonable one given how thin it is.
The coating is fired into the glass surface during manufacture rather than applied afterwards, so it is part of the glass rather than a film on it. It does not peel, flake or wash off, and it is not consumed by the reaction it catalyses. Under normal conditions it lasts the life of the unit.
What can compromise it is abrasive cleaning or the wrong chemicals, which is covered below.

How to clean it, when you do
Self cleaning glass is cleaned differently from ordinary glass, and getting it wrong is the main way people damage it.
- Fresh water and a soft cloth or a soft brush. Most of the time that is all it needs.
- Mild detergent where necessary, rinsed off thoroughly.
- Never abrasive pads, scrapers or scouring products.
- Never silicone based or water repellent cleaners, which defeat the hydrophilic surface.
- Avoid glass cleaners that leave a residue, for the same reason.
A water repellent product applied to self cleaning glass makes water bead instead of sheet, which disables the half of the mechanism that actually removes the dirt. It is a common and entirely avoidable mistake.
It takes time to settle
The coating needs a period of exposure to daylight after installation before it is fully active, which is generally days rather than weeks.
During that time and for a while afterwards the glass behaves more like ordinary glass, and people occasionally conclude it is not working. It also performs best once the surface has been through a few cycles of rain, which is not usually a long wait here.
It is worth knowing so that a judgement is not made in the first fortnight.
What it does for the view
A modest and genuine benefit that is separate from the cleaning.
Because water sheets rather than beads, rain on a self cleaning rooflight distorts the view less. Looking up through a pitched unit in rain, the difference between a film and a field of droplets is noticeable, and on a lantern over a kitchen it is pleasant.
It also means the glass dries without spotting, so the interval during which the unit looks marked after rain is shorter.
The interaction with solar control
The two coatings are on different surfaces and they coexist without difficulty.
Self cleaning is on the outermost face, exposed to the weather. Solar control is on a cavity face, protected inside the sealed unit. Specifying both is routine and neither compromises the other.
What is worth checking is that both are actually on the order, because they are separate line items and it is easy for one to fall off.

Whether it is worth the money
The honest test is what it would cost you not to have it.
On a lantern nobody can reach, where the alternative is a cleaning contractor with access equipment every year or two, it repays itself quickly and it is the easiest specification decision on the order.
On a low bungalow rooflight that can be reached from a stepladder in ten minutes, it is a convenience rather than an economy, and the money might do more in the glass specification.
On a flat roof at minimum fall it is doing least, and we would generally say so rather than adding it.
Frosted, patterned and laminated combinations
Self cleaning is available on a range of glass types and there are combinations worth checking rather than assuming.
It coexists with a laminated inner pane without difficulty, which matters because every overhead unit has one. It coexists with solar control, as above. Where it gets more limited is on obscured or patterned glass, since the coating wants a smooth surface for the water film to run across, and a textured outer face interrupts that.
On a rooflight the obscured pane, where one is wanted, is generally the inner one for privacy, so this rarely arises. It is worth confirming on the order where any non standard glass is involved.
What it does to bird droppings and lichen
The two soiling problems people ask about specifically, and they behave differently.
Bird droppings are largely organic, so the coating works on them, and on a pitched unit with reasonable rainfall they clear considerably faster than on ordinary glass. On this coast gulls produce rather more of this than most places, so it is a real benefit on a lantern.
Lichen is a living organism rather than a deposit, and it establishes on surfaces that stay damp. The coating discourages it, because a surface that sheets water dries more evenly and holds less of the organic film lichen colonises. On a north facing slope that stays wet, it slows establishment rather than preventing it.
What it will not do
It will not keep glass looking newly cleaned. It reduces soiling and slows accumulation, and a unit with a self cleaning coating after three years looks considerably better than one without and not like one cleaned last week.
It does nothing for the inside of the glass, which on a rooflight is cleaned by rotating the sash through or is not cleaned at all on a fixed unit.
And it does nothing for the frame, the flashing or the recess, which on a coastal roof are the parts that need the rinse anyway.
What we recommend on the glazing
We recommend it where the pitch supports it and the unit is hard to reach, which on a lantern is nearly always. We say plainly that it reduces rather than removes cleaning on a coastal roof, because salt is not organic and the marketing does not mention it. On a flat unit at minimum fall we will tell you it is doing less than the brochure implies.
Where a unit is being ordered for a position we cannot see the pitch of yet, we hold the decision until the survey rather than adding it to the quotation speculatively. It is a small line on an order and it is one of the few options where the right answer genuinely depends on a number nobody has measured.
It is a good coating with a condition attached, and the condition is pitch.
Thinking about this job? We survey across Worthing, West Sussex and the South Downs and give you a fixed price before any work starts, with a 10-year workmanship guarantee.