When a loft becomes a habitable room, one window in it usually has to do more than let light in. It has to be capable of getting somebody out, and that turns a preference about size into a dimension set by regulation.
This page sets out what the requirement is, what it means for the window, and where it sits in a loft conversion.
What makes a room habitable
A loft used for storage is not a habitable room. A loft converted into a bedroom, a study, a playroom or any other space intended to be occupied is, and the moment it becomes one a set of requirements applies that did not before.
That distinction is worth understanding, because a great many lofts in this area were boarded and lit at some point without any of this being considered, and the question surfaces when the house is sold.
Two ways out
The principle behind the requirement is simple: somebody asleep in a room at the top of a house must be able to get out if the stair is not usable.
There are two routes to satisfying that. Either the stair itself is protected so that it stays usable, which means fire resisting construction and self closing doors along its whole length, or an escape window is provided in the room so that a person can get out through it.
Which route a conversion takes is a decision made with Building Control, and it depends on the house, the number of storeys and what is practical. Both are legitimate and the window route is the one that concerns us here.
The clear openable area
The requirement is expressed as a clear openable area with minimum dimensions in both directions, and all three conditions have to be satisfied at once: the area, the height and the width.
The word that does the work is clear. It means the unobstructed opening a person can actually pass through, not the size of the window or the size of the hole in the roof.
| Dimension | Counts | Does not count |
|---|---|---|
| Width | Between the frame reveals with the sash open | The outside width of the frame |
| Height | From the opening sill to the head, clear | The full height of the window |
| Area | The product of the clear width and clear height | The glazed area |
| Obstruction | Nothing in the opening when the sash is open | A pivoted sash sitting across the middle |
Why a centre pivot rarely works
This is the practical consequence and it decides the product.
A centre pivot sash, when open, sits across the middle of the opening: the top half outside, the bottom half inside. The clear space available is the gap above the sash or the gap below it, and each of those is well under the whole.
A top hung sash swings clear of the opening entirely, so the full opening is available. That is why escape windows are top hung, and why manufacturers make specific escape models with a sash that opens to a large angle.

Sill height
The height of the bottom of the clear opening above the floor is controlled as well, from both directions.
Too high and a person cannot climb through it, particularly a child or somebody who is not able bodied. Too low and it becomes a fall hazard in ordinary use.
On a pitched roof the sill height above the floor is a function of where the window sits up the slope and how steep that slope is, which means it is set by geometry rather than chosen. On a shallow pitch the window has to sit further up the slope to achieve the same height, which pushes it away from the eaves.
Where it lands on the roof
Put those two constraints together and the window position is largely determined before anybody expresses a preference.
It has to be low enough that the sill is within the permitted range, high enough that the head gives the clear opening height, and positioned so that the whole assembly fits between the rafters or within a trimmed opening. On a steep roof there is a comfortable band; on a shallow one the band is narrow.
That is why the escape requirement is established at survey, before a size or a position is discussed, rather than being checked afterwards.
Getting out of it, and where you land
An escape window opens onto a roof, not onto the ground. What happens next is part of the assessment.
The intention is that a person can get out onto the roof and wait to be rescued, or reach a lower roof, a flat roof or a place of relative safety. A window opening straight onto a steep slope four storeys above a concrete yard is a different proposition from one opening onto the shallow roof of a rear addition.
Building Control will look at this, and on some houses it is the reason the protected stair route is chosen instead.
One window, or more
The requirement is normally one escape window per storey rather than one per room, provided the rooms on that storey have access to it without passing through a risk.
In a typical loft conversion of one or two rooms, that means one escape window, and the other rooflights on the same storey can be whatever suits the room. It is worth knowing, because it means the escape window can be positioned where it works best and the rest chosen freely.

The rest of the conversion
An escape window is one requirement among several, and it is worth naming the others so the picture is complete.
- Fire resisting construction to the floor of the new storey, so the storey below is separated.
- Fire doors on the rooms off the stair, self closing where required.
- Interlinked smoke alarms on every storey.
- A stair meeting the requirements for headroom, going and pitch.
- Structural work to carry the new floor, frequently on new beams.
- Insulation and ventilation to the new roof construction.
We install rooflights rather than build loft conversions, and the escape window has to be right within somebody else’s scheme, which is why we ask what the wider project is before specifying.
Bungalow lofts
A bungalow converted into a room in the roof is a two storey house afterwards, and the requirements follow from that rather than from what it used to be.
This is common along the coast here, where the bungalow stock is large and the plots are valuable enough to make a conversion worthwhile. The escape window requirement applies exactly as it would in any other house, and the fact that the new room is only one storey up does not remove it.
What the low height does help with is where a person lands, since a bungalow roof is close to the ground.
Rooms that were converted before anybody asked
A good number of lofts in this area were floored, lined and used as bedrooms decades ago without a conversion in the regulatory sense.
Those rooms frequently have a rooflight that is too small, too high, centre pivot, or all three. The room has been slept in for twenty years and nothing has happened, and the question arrives when the house is being sold and a solicitor asks for the completion certificate that does not exist.
Fitting a compliant escape window is one part of regularising that, and it is not the whole of it. We say so plainly rather than implying that a window on its own makes an unregularised conversion compliant.
Regularisation
Where work was done without approval, a local authority can issue a regularisation certificate after the fact, having inspected what is there.
It usually involves opening up so the construction can be seen, and bringing anything that falls short up to standard. An escape window is frequently on that list and it is rarely the only item.
It is worth doing before a sale rather than during one, because during a sale it becomes a negotiation with a deadline.
Escape windows and the older Sussex roof
On a cut roof with a purlin, the escape window has to satisfy the sill height and the clear opening while fitting into the slope available, and the purlin is frequently in the middle of the useful band.
That is one of the places where the position genuinely is constrained on both sides, and where the answer is sometimes a designed alteration to work round the purlin rather than accepting a window in the wrong place.
On a trussed roof the width available between trusses may be less than an escape window needs, and a designed alteration is then the route rather than an option.

Conservation areas, and the conflict
An escape window is larger than a rooflight chosen for light alone, and larger is more visible.
In a conservation area or inside the National Park, that creates a genuine tension: the regulation sets a minimum size and the planning position prefers something small and flush. The tension is real and it is resolvable, usually by putting the escape window on a rear or concealed slope and using smaller flush units on any visible one.
Establishing both requirements before designing the layout is the way through it, and it is another argument for pre-application advice on a sensitive building.
The specification we would write
- A top hung escape model, confirmed against the manufacturer clear opening figures rather than the nominal size.
- Positioned so the sill height falls within the permitted band, measured on site from the finished floor.
- Sized to fit the structure available, or with the structural alteration designed alongside it.
- Laminated inner pane, as on any overhead glazing.
- Coastal specification on fixings and coating where the site warrants it.
- Notified to Building Control, with the completion certificate coming to you.
What the manufacturer figures mean
Manufacturers publish a clear opening figure for each escape model, and it is the figure to work from rather than the frame size.
It differs between models in the same range and between ranges from the same maker, and it changes with the opening angle the sash achieves, which in turn depends on the roof pitch. A model that gives a compliant clear opening at forty five degrees may not at twenty five.
We check the figure against the measured pitch of your roof, for the specific model, before it goes on the order.
What we ask first on a pitched roof
We ask at survey whether the loft is or will be a habitable room, because that answer changes the product entirely. Where an escape window is required we confirm the clear opening against the model and the measured pitch, set the sill height from the finished floor, and notify Building Control. Where the wider conversion is somebody else’s work we coordinate the window with their scheme rather than fitting in isolation.
An escape window is not a large rooflight. It is a specified opening that happens to also be a window.
Thinking about this job? We survey across Worthing, West Sussex and the South Downs and give you a fixed price before any work starts, with a 10-year workmanship guarantee.