Energy Efficient Rooflights

Can you add solar control to an existing rooflight?

Not the coating itself. Solar control is applied to an internal surface of the sealed unit during manufacture, so it cannot be added to glass already in place. What can be retrofitted is an applied film, which does work and carries real limitations, and there are two better options depending on the situation.

Why the coating cannot be added

Because of where it lives.

The coating sits on one of the internal faces of a sealed unit, protected inside the cavity. Reaching it means breaking the seal, which means replacing the glass.

Which is also why the coating cannot be scratched, cleaned off or degraded by weather.

What a film is

A polyester sheet with a metallic or ceramic coating and an adhesive backing, applied to the inner face of the room side pane.

It reflects and absorbs a share of the incoming energy, and good ones are genuinely effective at reducing solar gain.

The first limitation: position

It is on the wrong side of the glass, and that costs it performance.

Energy rejected by a coating inside the sealed unit is rejected before it has passed through the outer pane. Energy rejected by an internal film has already entered the unit.

Some of what the film absorbs is then re-radiated inward, so it performs less well than a factory coating with the same nominal figures.

The second limitation: thermal stress

The one that matters most, and it is a real risk.

A film makes the glass absorb more energy than it was designed to, which heats it unevenly, particularly where a pane is partly shaded by a frame or a blind.

On a toughened pane that is generally tolerable. On an annealed pane it can crack it, and in a sealed unit the stress also works on the edge seal.

What that means for a warranty

Frequently, that it ends. Most sealed unit manufacturers exclude damage arising from applied films, and applying one to a unit still in warranty is a decision to give that up.

It is worth reading the terms before rather than discovering it during a claim.

A rooflight sealed unit seen edge on against the light, the warm edge spacer bar and the low emissivity coating visible as a faint tint in the glass, clean and technical
The third limitation: appearance

The third limitation: appearance

Films are more visible than coatings, and they age.

A film can show a mirrored or bronze cast, and over years it can craze, bubble at the edges, or discolour, which a factory coating does not do.

On a rooflight directly overhead, that ageing is in view.

When a film is nonetheless the right answer

Where the alternatives are worse. A sound unit in a difficult position, a rented property where replacement is not an option, or a room that is only just uncomfortable and does not justify new glass.

Applied by somebody who does it properly, to a suitable pane, it is a reasonable measure.

The first alternative: a blind

Usually better, and always simpler.

An external blind or awning stops the energy before it reaches the glass and is far more effective than any film. An internal blind is less effective and still helps.

The comparison is on do blinds reduce heat through a rooflight.

The second alternative: ventilation

Frequently the actual problem rather than the glass.

A room that cannot purge warm air will overheat whatever the glass does. Where an existing rooflight is fixed, adding a means of ventilation can matter more than treating the glazing.

What actually causes overheating is on will a rooflight make my room too hot.

The third: replacing the glazing

Cheaper than people assume, on many units.

Where a frame is sound, the sealed unit can frequently be replaced on its own with a solar control one, which gives the factory coating and its performance without a new rooflight.

Whether it is available depends on the model and the age, and it is the first thing worth asking.

Replacing the whole unit

The last option, and it is sometimes the sensible one.

Where a unit is old, misting, or a poor performer generally, replacing it solves the solar problem alongside everything else rather than treating one symptom.

A cutaway section of a triple glazed rooflight unit showing the two cavities, the warm edge spacers and the thickness of the laminated inner pane
Films on a laminated pane

Films on a laminated pane

A specific caution worth naming. Applying a film to a laminated inner pane can trap heat at the interlayer, and some manufacturers advise against it entirely.

It is a product question rather than a general rule, and it is worth asking before applying anything.

Who should apply one

Somebody who fits films for a living, working overhead.

Applying film to a rooflight is harder than to a window: it is above the installer, dust falls onto the adhesive, and bubbles are unforgiving.

What it will not do

Improve the U-value meaningfully, or fix glare on its own.

A film addresses solar gain. Heat loss and brightness are different problems with different answers.

External films

A variant worth knowing about and rarely the answer here.

Films made for external application exist and perform better than internal ones, because they reject energy before it enters the glass at all.

They also weather, they are exposed to everything a roof gets, and applying one to a rooflight means working on the roof. On a domestic unit an external blind is generally the better use of the same effort.

What a good film actually achieves

Worth being fair about, because the limitations above are not the whole story.

A quality ceramic film applied properly to a suitable pane will reduce solar gain substantially and noticeably improve a room that was uncomfortable.

The caution is about which pane it goes on and what it does to a warranty, rather than about whether it works.

The question we start with on the glazing

We ask whether the sealed unit can be replaced before considering a film, because a factory coating outperforms an applied one and carries its warranty.

What the coating actually is is on what is solar control glass.

Thinking about this job? We survey across Worthing, West Sussex and the South Downs and give you a fixed price before any work starts, with a 10-year workmanship guarantee.

Get a fixed quote

Get a fixed quote

Tell us about the roof. We will tell you the price.

A survey costs you nothing and there is no obligation attached to it. We look at the roof build-up, the exposure and the opening, and give you one fixed figure, not an estimate that moves once work starts.

If your rooflight is leaking now, say so and we will prioritise the survey.

  • Fixed price, confirmed in writing
  • 10-year workmanship guarantee
  • Installed to current Building Regulations
  • Your roof is never left open overnight
Call Get a fixed quote